Compressor design features and benefits
1. Horizontal configuration – low vibration requiring no special foundations
2. Castings in SG Iron meet stringent European environmental regulations
3. Pressurized crankcase eliminates gas venting to atmosphere during normal operation & stand by modes.
4. Crankcase pressure fed oil to all bearings & crossheads eliminates requirement for bolt-on lubricator system.
5. Exclusive low friction cylinder treatment in certain cases – longer ring life at high pressure.
6. Cylinders lubricated by oil carried in the gas stream simplifies compressor maintenance
7. Uses SAE 40 lubricating oil - readily available
8. Fully lubricated design significantly reduces wear on valves & rings
|
 |
 |
Principal Components
|
| Item |
Material |
Spec. |
Feature |
| Crankcase |
SG Iron |
40 barG |
gas tight, heavy duty heavily ribbed, single casting |
| Main Bearing |
Spherical Roller |
160 mm |
double row, self-aligning |
| Crankshaft |
SG Iron |
88.9 mm |
counter balanced & balanced to eliminate vibration |
| Crankshaft stroke |
|
82.55 mm |
1800 rpm allows direct coupling to engines / motors |
| Connecting Rods |
SG Iron |
|
rugged and tough with precision bearing shells |
| Wrist pin |
Hardened Steel |
63.5 mm |
full floating design, lower wear on bearings |
| Gudgeon Pin Bearing |
Bronze |
shell |
large bearing surface ensures long life |
| Crosshead Piston / Cylinder |
Gray Iron |
152.4 mm |
generous bearing face reduces heat load, low-friction coating |
| Piston Rod |
4140 Rc50 |
28 mm |
hard wearing surface for long life |
| Cylinders |
SG Iron |
as above |
non-cooled |
